Casio XJ-S43W User Manual page 44

Indicator/Error Message
POWER : Amber flashing
Red steady
TEMP : Red flashing
(0.5-second interval)
LAMP : Red flashing
(0.5-second interval)
Message : –
POWER : Amber flashing
Red steady
TEMP : Red flashing
(2-second interval)
LAMP : Not lit or red flashing
Message : –
POWER : Amber flashing
Red steady
TEMP : Amber flashing
(1-second interval)
LAMP : –
Message : –
POWER : Green steady
TEMP : –
LAMP : Red flashing
(1-second interval)
Message : It is time to replace the
lamp. Use the
procedure in the User's
Guide to replace the
lamp as soon as
possible.
POWER : Amber flashing
Red steady
TEMP : –
LAMP : Red steady
Message : The lamp has exceeded
its service life! The
projector will not turn
on until you replace the
lamp.
Description and Required Action
The projector was turned off automatically because the lamp turned
off or did not turn on. After confirming that the POWER/STANDBY
indicator is lit red (without flashing), unplug the power cord. Wait for
a short while and then plug it back in and turn on the projector
again.
If the error occurs again when you turn power back on, wait until
the projector cools down and then replace the lamp (page 37).
If the lamp does not light after you replace it, contact your retailer
or nearest authorized CASIO Service Center.
Power has turned off automatically due to a projector memory error.
Confirm that the POWER/STANDBY indicator is lit red (without
flashing). After checking the POWER/STANDBY indicator, disconnect
the power cord from the projector and wait for all of the projector's
indicators to go out. Next, reconnect the power cord and turn
projector power back on.
If the error occurs again when you turn power back on, contact your
retailer or nearest authorized CASIO Service Center.
Power has turned off automatically because the lamp cover is open.
Perform the following steps.
1 After confirming that the POWER/STANDBY indicator is lit red
(without flashing), disconnect the power cord from the projector.
2 Check to make sure that the lamp cover is closed.
3 Plug the power cord back in and turn the projector back on again.
If the error occurs again when you turn power back on, contact your
retailer or nearest authorized CASIO Service Center.
It is time to replace the lamp. Replace the lamp following the steps
"
under Replacing the Lamp" (page 37). Press the [ESC] key to clear
the warning message.
The allowable life for the lamp has been exceeded, and the projector
will not turn on. Replace the lamp following the steps under
"
Replacing the Lamp" (page 37).
44