HYPERICE Hypervolt Go 2 Operating Instructions Manual page 4

CAUTION
The battery used in this device may present a risk of fire or chemical burn if
mistreated. Do not disassemble, heat above 100º C or incinerate. Dispose
of used battery promptly. Keep away from children. Do not disassemble and
do not dispose of in fire.
SAVE THESE
INSTRUCTIONS
The Hypervolt Go 2 is a handheld percussion massage device that delivers
targeted pulses of pressure to care for muscles, relieve tension, provide
a relaxing massage, accelerate warmup and recovery, and help maintain
flexibility and range of motion.
Operating
Press down the power/speed button on the back of the device. Hold for
two seconds until the battery level indicator (LED band) illuminates, then
release. Your Hypervolt Go 2 is now ready for use. Choose your desired
speed (1-3) by pressing the power/speed button once per speed. The white
lights on the back will indicate speed setting. To power off, simply hold the
power/speed button down for two seconds.
Changing head attachments
Only change attachments after speed setting is turned to off and head
attachment stopped moving. To change head attachments, pull the existing
head attachment straight out to remove and insert the desired head directly
into the opening while pushing firmly. For the Fork head attachment align
the tab on the fork with the groove on the opening and push firmly.
Charging
Fully charge battery for up to four hours before first use. To charge, connect
the DC end of the supplied 18V charger to the charging port on the bottom
of the handle and plug the charger into a wall outlet. The LED light band
will pulsate to show battery level and indicate active charging. The LED
light band colors correspond to the charge level ranging from red (low) to
green (fully charged). Full charge is indicated when the LED band remains
green and fully illuminated. Battery may be recharged at any time and at
any battery level. It is not recommended to fully deplete the battery to the
red LED level. The average runtime is 2+ hours depending on speed level
and pressure applied during use. It is recommended to turn the device OFF
while the it is not in use or during storage and travel.
Cleaning and storage
Make sure the power is OFF and the battery charger is not attached. Use
a damp, clean cloth and gently wipe your Hypervolt Go 2. Store in a clean,
cool place, out of direct sunlight, when not in use.