Cautions During Disassembly And Assembly - Takeuchi TB53FR Workshop Manual

CAUTIONS DURING DISASSEMBLY AND
ASSEMBLY
1. Clean the machine before disassembly operation.
2. Before disassembly, check the machine condi-
tions and record them.
• Model, Machine Serial Number, Hourmeter
• Reason for Repairs, Repair History
• Dirtiness of Filters
• Fuel and Oil Conditions
• Damage to each parts, etc.
3. To make reassembly operations easy, make match-
ing marks at the necessary points.
4. Clean all disassembled parts and new parts, then
arrange them in the proper sequence.
5. Be sure to replace all seals and cotter pins, etc.,
with new parts.
6. Keep parts which should not come in contact with
oil and water separate from parts with oil on them.
• Electrical Parts, Rubber, V-Belts, etc.
7. When installing bearings, bushings and oil seals,
as a rule, use a press. When a hammer, etc., is
used, it leaves bruises.
8. Wipe all joining surfaces clean so that there is no
dirt or dust adhering to them.
9. Wrap seal tape from the front end, Wrapping it
tight and leaving 1 or 2 threads bare, Overlap the
tape by about 10 mm.
10. When fitting the snap rings, the bigger, rounder
side of their circumferences should face the mat-
ing surfaces.
SEALING TAPE
LEAVE 1 OR 2 THREAD MARGIN
I-9
GENERAL
TB53FR