Reattaching the Lens Cover
Use the following procedure to replace the lens cover if it should accidentally become
detached from the projector.
1
Insert the nub (
tab under the lens.
When performing the above step, make sure that the lens cover is open to 90 degrees in
relation to the front of the Data Projector.
2
Keeping the left nub (
towards the right as you insert the nub (
2
depression (
) of the right tab under the lens.
Do not apply undue force to the lens cover when performing the above step. Pressing too
strongly can damage the tabs of the lens cover.
3
) of the left tab of the lens cover into the depression (
3
) in the left depression (
1
), gently press the lens cover
4
) of the right lens cover tab into the
33
1
) of the
Press here with a pen or
similarly pointed object as
you slide the cover into
place.