Sony SMP-U10 Operating Instructions Manual page 13

8
Press X/x to select the type of jack
(if any) you are using to connect to
an audio component, then press
ENTER.
Select "NO" if you do not connect an
audio component, then go to step 10.
Select "YES: LINE OUTPUT L/R
(AUDIO)" if you connect an audio
component using an audio cable, then go
to step 10.
Select "YES: DIGITAL OUTPUT" if
you connect an audio component using a
digital coaxial cable/HDMI cord.
9
Press X/x to select the type of
Dolby Digital signal to your audio
component.
If your audio component has a Dolby
Digital decoder, select "DOLBY
DIGITAL." Otherwise, select "D-PCM."
10
Press ENTER.
Quick Setup is finished and connections
are complete.
If your audio component has an MPEG
audio decoder, set "MPEG" to "MPEG"
in "AUDIO SETUP" (page 24).
b
When "PhotoTV HD" mode is activated (page 16),
the selection for "TV TYPE" is skipped.
13