Table of Contents
Advertisement
H. Non-Combustible Facing Board
(Provided)
WARNING! Risk of Fire!
) R OORZWKHV H L Q V W UX F WL R QV H[ D FWO\
) D FL Q J P D WHUL D OV P X V W EHL Q V W DOOHGS U RS H UO\ WRS U HY H QW
¿ U H
1 R P D WHUL D OV P D \ EHV X E V W L W X W HGZL W KRX W DX W KRUL ] D WL R QE\
+ H DUWK+ R P H 7 H FKQRORJ L H V
TOOLS NEEDED: Powered drill with #2 Phillips head bit;
caulking gun.
Only non-combustible materials (supplied with fireplace)
may be used to cover the metal fireplace front.
NOTE:
$ O OERDUGV DUH S U HGUL O OHG
% R DUG V 0 8 6 7
EH DWWDFKHG
ERWWRP V L G HV
DQG WKHQ W KH W RS UHGS D L Q WHG V L G H RX W
7 K H WRS DQG ERWWRP ERDUG V K RX O G HDFK KDY H D KDQJ
WDJ DWWDFKHG
/HDY H WKHP DWWDFKHG
¿ Q L V K L Q J RS H UDWL R Q
• Attach the bottom board to the bottom of the outer
fireplace outer shell with enclosed screws, ensuring the
board is centered. DO NOT remove hang tags.
the side pieces to the outer can and framing members.
See Figure 3.11.
•
Center and attach the top board to the outer shell and
framing members.
DO NOT remove hang tags.
NOTICE:
L Q RI WKH I DFL Q J P D WHUL D O P D \
DIWHU ¿ Q L V K L Q J
P D WHUL D OV DUH DS S O L H G 7 K L V
EHS D L Q WHGRUWKHUHGZL O OV K RZ
Top Board
Side Boards
Bottom Board
Figure 3.11 Apply Non-combustible Materials
IRU \ R X U FRQY H QL H QFH
L Q WKH IROORZ L Q J RUGHU
IRUUHIHUUDO
EHY L V L E OH
Majestic • WarmMajic-II Installation Manual • 4188-901 • Rev F • 02/22
I. Outside Air Kit
An outside air kit must be used for combustion. Hearth &
Home Technologies recommends you utilize the shortest
duct run and install a P-trap (see Figure 3.18) to optimize
the performance of the outside air kit with a maximum
length of 40 ft. The outside air inlet hood should be posi-
tioned in a manner that will not allow snow, leaves, etc. to
block the inlet. In some installations the air duct may need
to be run vertically. In such an installation, a 3 ft (914 mm)
height difference must be maintained from the top of the
uppermost chimney section to the outside air inlet hood.
Refer to Figures 3.19 and 3.20 when placing the outside
air inlet hood.
NOTE: The minimum cross-sectional area of the inlet
hood is 17.5 square inches.
The outside air kit comes installed on the right hand side
of the fireplace but may be moved to the other side by fol-
IRUWKH
lowing these steps:
1. Remove outside air collar (Figure 3.12) and the outside
air cover plate (Figure 3.13).
2. Install the cover plate on the right side and the collar
Attach
on the left side.
3. Open and remove the lower access panel.
4. Remove the two (2) outer screws (Figure 3.16) to allow
the outside air box to be removed.
5. Pull the outside air box straight out. See Figure 3.17.
L Q P X V W
6. On the left side, remove the cover plate two (2) screws.
See Figure 3.14.
7. Install the cover plate on the right side where the
outside air box was and install the outside air box in
through the hole on the left side where the cover plate
was.
• Cut a 6-1/2 in. (165 mm) hole in outside wall to
accommodate air piping.
• Use 6 in. (152 mm) metal flex or rigid piping (not supplied)
to directly connect outside air to fireplace intake. Insulate
the pipe to prevent frost condensation. See Figure 3.18.
• Insulating the pipe isn't required but will help prevent
frost condensation.
•
Use the supplied outside air inlet hood.
• Seal between the wall and the pipe with silicone to
prevent moisture penetration and air leaks.
• Seal between the outside air inlet hood and the house
with silicone to prevent air infiltration.
CAUTION! Risk of Fire or Asphyxiation! DO NOT GUDZ
RX W V L G H FRP E X V W L R Q DL U IURP ZDOO À R RU RU FHL O L Q J FDY L W \ RU
HQFORV H GV S D FHV V X F KDV DQDWWL F RUJ D UDJ H
DO NOT S O DFHRX W V L G H DL U L Q OHW K RRG FORV H WR H[ K DX V W
•
Y H QWV RU FKL P Q H\ V
WKHURRP WKURX J K WKH¿ U HS O DFH
‡ /RFDWHRX W V L G H DL U L Q OHW
OHDY H V V Q RZL F H RU RWKHU
FRP E X V W L R QDL U V W DUY D WL R Q
) X P H V
RU RGRU F RX O G EHGUDZQ L Q WR
KRRG WR S U HY H QW EORFNDJ H IURP
GHEUL V % O RFNDJ H V FRX O G FDX V H
15
Advertisement
Table of Contents
