Table of Contents
Advertisement
Problem
The program does not start.
The appliance door does not close.
The appliance stops during operation.
The cycle time is too long or unsatisfacto‐
1)
ry drying result.
The display shows
1) After maximum 6 hours, the program ends automatically.
2) It can happen that some area remains humid when drying big items (e.g. bed sheets ).
If the drying results are not
satisfactory
• The set program was incorrect.
• The filter is clogged.
• The Heat Exchanger is clogged.
• There was too much laundry in the
appliance.
• The drum is dirty.
Possible solution
Check fuse in fuse box (domestic installa‐
tion).
Press Start/Pause.
Make sure that the appliance door is
closed.
Make sure that the installation of the filter
is correct.
Make sure that the laundry is not caught
between the appliance door and the rub‐
ber seal.
Make sure that the water container is
empty. Press Start/Pause to start the pro‐
gram again.
Load is too small, increase the load or
use the Time Drying program.
Make sure that the weight of the laundry
is suitable for the duration of the pro‐
gram.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry
in the washing machine again.
Ensure that the room temperature is
higher than +5°C and lower than +35°C.
Optimal room temperature is 18°C to
25°C.
Set the Time Drying or the Extra Dry pro‐
2)
gram.
If you want to set a new program, deacti‐
.
vate and activate the appliance.
Make sure that the options are suitable
for the program.
• Incorrect setting of the conductivity
sensor ( See chapter "
Adjustment of the remaining laundry
moisture degree " for better setting).
• The airflow slots are clogged.
• Room temperature is too low or too
high ( optimal room temperature 18°C
to 25°C )
ENGLISH
19
Settings -
Advertisement
Table of Contents
