Table of Contents
Advertisement
12
www.electrolux.com
To memorise your
configuration:
1. Press the on/off button to activate the
appliance
2. Set the program and available
options.
3. Press the (E) button for some
seconds.
The sound and the message on the
display confirm that the configuration is
memorised.
To activate your memorised
configuration:
1. Press the on/off button to activate the
appliance.
2. Use the program knob to set
Favourite
Previously memorised configuration of
program and options will be restore.
8.3 Adjustment of remaining
laundry moisture
The appliance allows you to chose
between 3 levels corresponding to
different ranges of water hardness.
Dryness
level
Depending on the country, the water
hardness is expressed in equivalent
scales: e.g. French degrees (°f), German
degrees (°d), English degrees (°e),
mmol/l and ppm
If necessary, please contact your local
water authority to check the water
hardness in your area.
position.
the results
from the inclu‐
ppm
ded water
hardness kit.
< 150
C01-C03
150 - 300 C04-C05
> 300
C06-C07
Every time you enter in the
"Adjustment of remaining
laundry moisture" mode,
previously set degree of
remaining moisture will
change into next value ( e.g
previously set
change into
To change the default degree of
remaining moisture:
1. Press the on/off button to activate the
appliance.
2. Use the program knob to set any
program.
3. Wait approximately 8 seconds.
4. Press and hold buttons (E) and (D) at
the same time.
One of these indicators comes on:
•
the maximum dryness
•
the more dry laundry
•
the standard dry laundry
5. Press and hold buttons (E) and (D)
again until the indicator of the correct
level comes on.
If the display returns to
the normal mode (the
time of the selected
program from step 2. will
be displayed), while
setting the degree of
remaining moisture,
press and hold buttons
(E) and (D) once again
to enter to the
"Adjustment of remaining
laundry moisture" mode
(previously set degree of
remaining moisture will
change into next value).
6. After 5 s the display returns to normal
mode.
8.4 Water container indicator
By default, the water container indicator
is on. It comes on when the program is
completed or when it is necessary to
empty the water container.
will
).
Advertisement
Table of Contents
