Installation Instructions - Soleus Air KC-30H / KC-35H Operating And Installation Manual

WARNING
Excessive Weight Hazard Excessive Weight Hazard
Use two or more people to move and install Use two or more people to move and install
air conditioner. air conditioner.
Failure to do so can result in back or other injury. Failure to do so can result in back or other injury.
Remove packaging materials
Remove and dispose of/recycle all packaging materials.
Remove tape and glue residue from surfaces before turning
on the air conditioner. Rub a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water
and dry.
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your air conditioner.
Handle air conditioner gently.
1. Remove air conditioner from carton and place it on
cardboard.
2. Remove shipping screws from both sides of cabinet.
A. Shipping screw
NOTES:
Handle air conditioner gently.
Be sure your air conditioner cabinet does not fall out of the
opening during installation or removal.
The location where the power cord exits the air conditioner
should be no more than 4 ft (122 cm) from a grounded
3 prong outlet.
Do not block the louvers on the front panel.
Do not block the louvers on the outside of the air conditioner.
Attach Top Channel
NOTE: Attach top channel and side curtains to air conditioner
cabinet before placing cabinet in window.
1. Locate supplied bag of screws.
2. Place top channel on top of air conditioner cabinet, lining up
the 3 holes in top channel with the 3 holes on top of air
conditioner cabinet.

INSTALLATION INSTRUCTIONS

A
Window Installation (on some models)
Unpacking
3. Remove front panel by removed 2 phillips screws on both
bottom left right sides of front.
3A: Remove both knobs from control panel.
4. Remove ground screw and ground wire from front of air
conditioner base. Save ground screw.
5. Pull on handle to slide air conditioner out of cabinet. Place air
conditioner on cardboard.
6. Remove any paking foam from inside of unit.
NOTE: Do not lift, push, pull or remove any expanded
polystyrene (foam) from inside the air conditioner. It is not
packing material.
3. Using 3 - #10 x
channel to air conditioner cabinet.
A. Top channel
B. #10 x
8
A
B
A. Green ground wire
B. Ground screw
A
A. Handle
" pan-head Phillips screws, attach top
B B
B A
" pan-head Phillips screws (3)