Advertisement
BLENDER
1 Make sure the Gasket is pushed into the groove
of the Tumbler correctly to avoid leaking during
blending. If the Gasket is not placed correctly,
drink may leak out.
2 Fill the Tumbler with ingredients.
3 Place the Blender Container Base onto the
Tumbler and turn it clockwise until it is tight.
Gasket
1
2
Groove
7 Support Tumbler Unit while in use.
Ensure the Clamp (both side) is not
positioned as shown in Figure 1 to prevent
accidental damage on the Clamp (both side).
8 Switch ON the Blender by pressing the 'I'
marking area.
7
Figure1
⑩
Switch OFF and unplug.
⑪
Turn the Tumblerr Unit anticlockwise and
remove it from the Motor Housing.
⑩
Note:
• Maximum capacity: 500 mL. Do not operate with an empty Tumbler Unit.
• Fill the Tumbler with solid ingredients first, followed by liquid ingredients. To make a thinner drink, add
more liquid. For smoother operation, dice food into smaller pieces (1~2 cm), and blend with liquid.
• Not recommended to blend hard, high-fiber and viscous ingredients. However, if it is necessary to
blend hard and viscous ingredients, cut the hard ingredients into small pieces (example: cut the carrot
into 1 cm³ cubes) and fill the cut ingredients not exceeding half of the maximum capacity.
• If the Cutting Blade gets stuck, switch OFF the Blender, then unplug. Remove the stuck ingredients by
using a spatula (not provided). Do not use your finger to remove the ingredients.
• Reduce ingredients when appliance makes abnormal sounds or vibrates during operation.
• Replace the Blender Container Base with Tumbler Lid after blending.
• Recommended to pour drink with the Tumbler Lid fitted to the Tumbler. When the Tumbler Lid is fitted
to the Tumbler, always keep the Tumbler upright to avoid leaking.
8
4 Place the Tumbler Unit onto the Motor Housing
5 Turn the Tumbler Unit clockwise until the triangle
6 Plug in and switch ON the rated power supply
3
9 After blending, switch OFF by pressing the
8
⑫ Turn the Tumbler Unit upside-down.
⑬ Turn the Blender Container Base anticlockwise
⑭ Make sure the Gasket
⑪
by lining up the triangle marks on the Container
Base and Motor Housing as shown in A.
mark on the Blender Container Base is lined up
to the rectangle mark on the Motor Housing as
shown in B and a 'click' sound is heard.
source.
4
5
B
'O' marking area.
Support the Tumbler Unit until motor stops
completely.
to remove it from the Tumbler. Be careful and
remove it slowly to avoid spillage.
is in place correctly.
⑬
Turn the Tumbler Lid
slightly anticlockwise
and then clockwise
until it is tight. Your
⑫
drink is ready to
consume now.
6
A
Tumbler
Lid
Gasket
⑭
Advertisement
