Inserting The Network Card - SMC Networks SMC9432TX User Manual

Inserting the Network Card

1. Switch off all computer system components, unplug the com-
puter, and remove the computer cover.
2. Work in a static-free area and touch the computer chassis often
to equalize static charges.
3. Install the network card into an available bus-mastering PCI slot.
4. Make sure the network card is completely seated so that no
"gold fingers" are exposed.
Figure 1-3. Inserting the Network Card
5. For the SMC9432TX/MP and SMC9432FTX, connect one
end of the 3-pin WOL cable to J1 on the card, and the
other end to the "5V Standby" connector on the computer's
motherboard, as shown in Figure 1-3. (Refer to your
computer's installation manual to locate the 5V Standby
connector.)
I
NSTALLING THE
N C
ETWORK ARD
1-7