House/Start Battery Voltage Warning; Communication Error Warning; Low Fuel Level Warning; Depth Warning - Yamaha AR210 2020 Owner's/Operator's Manual

NOTICE
If the cause of overheating cannot be
found and corrected, take special precau-
tions to avoid major engine damage while
you return to shore.
Single engine overheating — Shut off the
overheating engine and use the properly
running engine to return to shore. Operate
at no-wake speed (8 km/h, 5 mph) to pre-
vent water from flooding the non-operat-
ing engine through the water intake. See
page 69 for information on the no-wake
mode.
Both engines overheating — If getting a
tow from another vessel is not possible,
operate both engines just slightly above
idle while you return to shore. If you can be
towed, refer to "Towing the boat" on page
188.

House/Start Battery voltage warning

If "House Battery" "Start Battery" appears on
the multi-function display and the buzzer will
sound, check the battery connections. If the
battery connections are clean and tight and
the warning indication continues, have a
Yamaha Boat Dealer check the charging sys-
tem.

Communication error warning

If a communication error is detected for the
GPS function, a sensor, or other device, a
warning will appear on the multi-function dis-
play and the buzzer will sound. If this occurs,
reduce the engine speed, return to shore, and
have a Yamaha Boat Dealer check the boat.

Low fuel level warning

If "Fuel Level" appears on the multi-function
display and the buzzer will sound, refill the
Instrument operation
fuel tank as soon as possible. (See page 120
for information on filling the fuel tank.)

Depth warning

If the boat enters an area that is shallower
than the water depth set for the depth alarm,
the depth warning will be activated and the
buzzer will sound.
If the warning is activated, move the boat to
an area that is deeper than the water depth
set for the depth alarm. (See page 86 for in-
formation on setting the depth alarm.)
91