Troubleshooting - Siemens Gigaset 4010 User Manual

Troubleshooting

Maintenance
Simply wipe the base station and handset with a damp cloth or an antistatic wipe.
Never use a dry cloth as this can cause static discharge!
Troubleshooting
If your telephone does not behave the way you want it to, first try to solve the prob-
lem using the following list. Siemens Customer Care 1-888-777-0211.
Problem
No display.
No reaction to keystroke. Keypad protection on
No radio connection to
the base station – all dis-
plays flashing.
Handset in the base sta-
tion is not charging.
The incoming call num-
ber is not displayed al-
though you have sub-
scribed to the caller ID
Service.
Error beep is generated
(descending tone se-
quence)
36
Possible cause
Handset not on
Batteries empty
Handset outside the base
station range.
Handset not registered
Base station off
Line seized by a second
handset for a long period.
The telephone number
transmission is blocked.
Wrong input
Solution
Hold down the end call

key for 1 second
Charge or replace the bat-
teries (see page 4).
4
Hold down the key
for 1 second
Move closer to the base
station.
Register the handset
see page 24.
Check the power connec-
tor at the base station
(see page 2).
Maximum charging power
is obest achieved when
phone is in idle state.
Callers must permit the
transmission of their tele-
phone numbers at their
network providers.
Repeat the procedure;
note the display and, if nec-
essary, refer to the operat-
ing instructions.