Safety Rules; Recommendations - Inventini PASCAL User Manual

SAFETY RULES

RECOMMENDATIONS

CAUTION
GENERAL TERMS
OF WARRANTY
www.inventini.com
1. Inflatable tent is not adapted to severe weather conditions such as
strong winds, heavy rains, storms or hailstorms.
2. The product is not adapted to snow load. In the event of snow
gathering, remove it from the roof regularly to avoid the tent collapsing.
3. In the event of water gathering, remove it immediately from the roof.
4. You shouldn't leave your tent unattended.
5. In case of strong winds, disassemble the tent.
6. Keep the product away from sources of heat and open flames.
Please do not place any sources of heat direclty at the product
beacuse the materials can melt at high temperatures.
7. By special order, you can have your product made of flame retardant
fabric (which meets the standards of B1 requirements).
1. Read these instructions carefully before you get to work.
2. Be cautious while setting up the tent to avoid being hurt and prevent
other damage.
3. Before disassembling the structure, the product must be thoroughly
cleaned. Any spots or stains on the fabric should be removed
immediately with a warm damp cloth. Do not use detergents or
pressure washers. Follow the instructions on the label.
4. Storing a dirty or damp product can result in a breakdown of the
materials as fabrics tend to mold, mildew and/or rot. Before putting
your product in its transport bag for storage, make sure it is clean
and dry. Store it in a dry place to avoid moisture contamination.
In case of bad weather, repack your product to avoid damage, but as
soon as it's possible, unpack it once again to let it dry.
5. With recurring gusts of wind, check anchoring systematically.
6. Tent may be used with wind up to 38 kph. During stronger wind, it is
recommended to disassembling the product.
7. Do not cover the safety valves in any case.
8. Take special care when transporting and storing the product.
9. Do not subject the product to mechanical impact, pressing other
products, etc.
The air in the product changes it's volume under the influence
of temperature. High temperature increases the volume of air. The product
becomes more taut. Low temperature reduces the volume of air.
The product becomes less taut.
General terms of warranty can be downloaded from the
manufacturer's website.
EN
5