Safety Rules; General Terms Of Warranty - Inventini PASCAL TENT User Manual

SAFETY RULES

RECOMMENDATIONS
CAUTION
GENERAL TERMS
OF WARRANTY
www.inventini.com
1. Inflatable tent is not adapted to severe weather conditions such as
strong winds, heavy rains, storms or hailstorms.
2. The product is not adapted to snow load. In the event of snow
gathering (over 2 cm), remove it from the roof regularly to avoid the
tent collapsing.
3. In the event od water gathering remove it from the roof immediately.
4. You shouldn't leave your tent unattended.
5. In case of strong winds (over 38 kph), disassemble the tent
(start with side panels, then dismantle the roof).
Mechanical damage resulting from non-compliance with the
instructions is not covered by the warranty.
6. Keep the product away from sources of heat and open flames.
Please do not place any sources of heat direclty at the product
beacuse the materials can melt at high temperatures.
7. By special order, you can have your product made of flame retardant
fabric (which meets the standards of B1 requirements).
1. Read these instructions carefully before you get to work.
2. Be cautious while setting up the tent to avoid being hurt and prevent
other damage.
3. Before disassembling the structure, the product must be thoroughly
cleaned. Any spots or stains on the fabric should be removed
immediately with a warm damp cloth. Do not use pressure washers.
Follow the instructions on the label.
4. Before putting your product in its transport bag for storage, make sure
it is clean and dry. Store it in a dry place to avoid moisture
contamination. In case of bad weather, repack your product to avoid
damage, but as soon as it's possible, unpack it once again to let it dry.
5. With recurring gusts of wind, check anchoring systematically.
6. Tent may be used with wind up to 38 kph. During stronger wind, it is
recommended to disassembling the product.
7. Do not cover the safety valves in any case.
8. Take special care when transporting and storing the product.
9. Do not subject the product to mechanical impact, pressing other
products, etc.
The air in the product changes it's volume under the influence
of temperature. High temperature increases the volume of air.
The product becomes more taut. Low temperature reduces the
volume of air. The product becomes less taut.
General terms of warranty can be downloaded from the
manufacturer's website.
EN
5