Carburetor Adjustment; High Altitude Operation - Shindaiwa X7502825900 Owner's/Operator's Manual

Shindaiwa brushcutter owner's manual
Table of Contents

Advertisement

Maintenance (continued)
Muffler and spark arrester maintenance
If the engine becomes sluggish and low
on power, check and clean the spark
arrester screen.
WARNING!
Never operate the unit with a
damaged or missing muffler or spark
arrester! Operating with a missing or
damaged spark arrester is a fire hazard
and could also damage your hearing.
1.
With a 3 mm hex wrench remove the
engine cover screws and the engine
cover.
2.
With a 4 mm hex wrench, remove the
3 muffler bolts and the muffler.
3.
With a small flat bladed screwdriver
remove the 2 screws holding the
spark arrester screen and cover to the
muffler.
4.
Remove the screen and clean it with a
stiff bristle brush.
5.
Inspect the cylinder exhaust port for
any carbon buildup.
6.
Reassemble the spark arrester, muf-
fler and engine cover in the reverse
order of disassembly.
IMPORTANT!
If you note excessive carbon buildup,
consult with an authorized servicing
dealer.

Carburetor Adjustment

Engine Break-In
New engines must be operated a minimum duration of two tanks of fuel break-in before carburetor adjustments can be
made. During the break-in period your engine performance will increase and exhaust emissions will stabilize. Idle speed can
be adjusted as required.

High Altitude Operation

This engine has been factory adjusted to maintain satisfactory starting, emission, and durability performance up to
1,100 feet above sea level (ASL) (96.0 kPa). To maintain proper engine operation and emission compliance above
1,100 feet ASL the carburetor may need to be adjusted by an authorized Shindaiwa service dealer.
If the engine is adjusted for operation above 1,100 feet ASL, the carburetor
must be re-adjusted when operating the engine below 1,100 feet ASL, oth-
erwise severe engine damage may result.
Every unit is run at the factory and the carburetor is set in compliance with
emission regulations. Carburetor adjustments, other than idle speed, must be
performed by an authorized Shindaiwa dealer..
Engine
Cover
Screws
IMPORTANT!
NOTE:
Engine Cover
Muffler
Muffler Gasket
Spark Arrester Screen
Spark Arrester Cover
Cover Screws
Muffler Bolts
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

C254

Table of Contents