Filling The Fuel Tank - Shindaiwa X7502825900 Owner's/Operator's Manual

Shindaiwa brushcutter owner's manual
Table of Contents

Advertisement

Mixing Instructions
1. Fill an approved fuel container with half of the re-
quired amount of gasoline.
2. Add the proper amount of engine oil to gasoline.
3. Close container and shake to mix oil with gasoline.
4. Add remaining gasoline, close fuel container, and
remix.
IMPORTANT!
Spilled fuel is a leading cause of hydrocarbon emissions.
Some states may require the use of automatic fuel shut-
off containers to reduce fuel spillage.
After use
• DO NOT store a unit with fuel in its tank. Leaks can
occur. Return unused fuel to an approved fuel storage
container.

Filling the fuel tank

WARNING!
Minimize the Risk of Fire
NEVER
smoke or light fires near the
engine.
ALWAYS
stop the engine and allow
it to cool before refueling.
ALWAYS
Wipe all spilled fuel and
move at least 3 meters (10 feet) from
the fueling point and source before
starting.
NEVER
place flammable material
close to the engine muffler.
NEVER
operate the engine without the
muffler and spark arrester screen in
place and in good working condition.
Storage - Fuel storage laws vary by locality. Contact
your local government for the laws affecting your area.
As a precaution, store fuel in an approved, airtight con-
tainer. Store in a well-ventilated, unoccupied building,
away from sparks and flames.
Stored fuel may separate. ALWAYS shake fuel container
thoroughly before each use.
FUEL IS HIGHLY FLAMMABLE.
ALWAYS
store gasoline in a con-
tainer approved for flammable liquids.
ALWAYS
inspect the unit for fuel
leaks before each use. During each
refill, check that no fuel leaks from
around the fuel cap and/or fuel tank. If
fuel leaks are evident, stop using the
unit immediately. Fuel leaks must be
repaired before using the unit.
ALWAYS
move the unit at least 3
meters (10 feet) away from a fuel
storage area or other readily flam-
mable materials before starting the
engine.
IMPORTANT!
1.
Place the unit on a flat, level
surface.
2.
Clear any dirt or other debris
from around the fuel filler cap.
CAUTION!
Slowly remove the fuel cap
only after stopping the engine
3.
Remove the fuel cap, and fill
the tank with clean, fresh fuel.
4.
Reinstall the fuel filler cap and
tighten firmly.
5.
Wipe away any spilled fuel
before starting engine.
11

Advertisement

Table of Contents
loading

This manual is also suitable for:

C254

Table of Contents