Table of Contents
Advertisement
12.8
Checking the free travel of foot brake lever
Warning
Danger of accidents The brake system fails in the event of overheating.
If there is no free travel on the foot brake lever, pressure builds up in the brake system on the rear
brake.
–
Set the free travel on the foot brake lever in accordance with the specification.
–
Insert the new brake linings, insert pin
5
pins
.
Info
Always change the brake linings in pairs.
To make it easier to mount the pin, push the brake
linings against the retainer spring.
Make sure the brake linings and retainer spring are
seated correctly.
F03696-10
–
Position the brake caliper.
–
Mount and tighten screws
Guideline
Screw, front
brake caliper
–
Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
F03695-10
–
Add brake fluid up to level
Guideline
A
Level
(brake fluid level
below reservoir rim)
Brake fluid DOT 4 / DOT 5.1 (
–
Position cover
–
Mount and tighten screws
Info
Use water to immediately clean up any brake fluid that
has overflowed or spilled.
F03693-10
BRAKE SYSTEM 12
6
, and mount cotter
4
.
M8
25 Nm (18.4 lbf ft)
A
.
5 mm (0.2 in)
p. 137)
2
3
with membrane
.
1
.
®
Loctite
243™
87
Advertisement
Table of Contents
