Connecting The Power Cord - Sharp AM-900 Online Manual

Connecting the power cord

Plug the power cord into a 120 V, 60 Hz, grounded AC (3-prong) outlet.
Caution: Make sure the scanner has been released as explained on the
previous page before plugging in the power cord.
Do not plug the power cord into any other kind of outlet. This will damage
the machine and is not covered under the warranty.
Comments:
The machine does not have a power on/off switch. The power is turned on
and off by simply plugging in or unplugging the power cord.
Whenever you unplug the power cord, wait at least 5 seconds before
plugging it back in.
If your area experiences a high incidence of lightning or power surges, it is
recommended that you install surge protectors for the power and telephone
lines. Surge protectors can be purchased from your dealer or at most
telephone specialty stores.
Installation
13