The Alignment Tool Outline; Menu Of The Tool; Rf Power (High); Rf Power (Low) - Vertex Standard VX-2500EV Service Manual

The alignment tool outline

Enter to the alignment mode
To enter the alignment mode, turn the receiver off, select
"Radio" then "Alignment" parameter on Clone Editor
"CE63". You turn off the power of the transceiver, and turn
on the transceiver. When the command has been success-
ful, a message on the computer screen will confirm that
the transceiver is now in the alignment mode.
Alignment Sequence
Although the data displayed on the computer screen dur-
ing alignment is temporary data, it is important you fol-
low the basic alignment sequence precisely, so that the
displayed data and the data loaded into the transceiver
are identical.
Basic Alignment Sequence
1. Enter the alignment mode
2. Upload data from trans-
ceiver
3. Align data
4. Download data to trans-
ceiver

Menu of the tool

RF Power (High)

This parameter is used to align RF High power.
Set the transceiver to CH#1 via the "CH" box lo-
cated upper left corner on the "Alignment" win-
dow previously.
To adjustment double-click the left mouse but-
ton on the "
up window.
Move the Slide bar, as need, to set the power
output to the following specification, as indicated
on the external wattmeter.
" box to open pop-
RF Power (High): 25[W] ±0.5W)
When the 25Watt level is attained, press the "OK"
box to lock in the new data.

RF Power (Low)

This parameter is used to align RF High power.
Set the transceiver to CH#2 via the "CH" box lo-
cated upper left corner on the "Alignment" win-
dow previously.
To adjustment double-click the left mouse but-
ton on the "
up window.
Move the Slide bar, as need, to set the power
output to the following specification, as indicated
on the external wattmeter.
RF Power (Low): 5[W] ±0.1W)
When the 5Watt level is attained, press the "OK"
box to lock in the new data.
Alignment
" box to open pop-
13