Alignment Channel Frequencies; Transmitter Output Power - Vertex Standard VXR-9000U-A Alignment Manual

Alignment Channel Frequencies

Channel Frequency
(simplex)
CH1 400.00MHz
CH2 407.50MHz
CH3 415.00MHz
CH4 422.50MHz
CH5 430.00MHz
CH6 400.00MHz
CH7 407.50MHz
CH8 415.00MHz
CH9 422.50MHz
CH10 430.00MHz
CH11 415.00MHz
CH12 415.00MHz
CH13 415.00MHz
CH14 415.00MHz
PLL & Transmitter
Set up the test equipment as shown for transmitter alignment.
Maintain the supply voltage at 13.8 V DC for all steps.
PLL VCV
Connect the positive lead of the DC voltmeter to the test point TP1001 (VCV) on the Main Unit, as
indicated in the figure, and the negative lead to chassis ground.
Key the transmitter, and adjust coil L1020 on the Unit for 1.5 V on the voltmeter.
Next select to the band center (low edge) frequency channel (CH2) and confirm about 6.8 V (6.5V –
7.2V) on the voltmeter.
Next select to the high band frequency channel (CH4) and confirm about 6.8 V (6.5V – 7.2V) on the
voltmeter.
Key the transmitter, and confirm about 6.8 V (6.5 V – 7.2 V) on the voltmeter.

Transmitter Output Power

Select band center frequency channel, and select high power output level.
Key the transmitter and adjust by control commands for high power from the computer for 50 ± 1 W as
indicated on the wattmeter.
Select band center frequency channel, and select low power output level.
Key the transmitter and adjust by control commands for low power from the computer for 10 ± 0.1 W
as indicated on the wattmeter.
CTCSS DCS Narrow
Encode Encode /wide
None None Wide
None None Wide
None None Wide
None None Wide
None None Wide
None None Narrow
None None Narrow
None None Narrow
None None Narrow
None None Narrow
151.4Hz None Wide
None 023 Wide
151.4Hz None Narrow
None 023 Narrow
4/5
FCC ID: K6610444140
IC ID: 511B-10444140
Alignment
Vertex Standard Co., Ltd.