Canon TU-06 Setup Manual page 21

7
Pull up the cord of the Media Take-up Sensor (a) through the hole (c) of the Right Stand Leg.
Put the Media Take-up Sensor under the Bottom Stand Stay (b) on the right.
Note
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
• The Media Take-up Sensor remains concealed in the Bottom Stand Stay.
8
With the Media Take-up Sensor against the underside of the Bottom Stand Stay and the
Right Stand Leg, insert M4 hex screws in the three holes (a) and slide the screws out of the
way toward the narrow end of the protruding holes. Insert M4 hex screws in the small holes
(b) as well. Use the Allen wrench to tighten all five M4 hex screws firmly in the order shown,
from (2) to (6).
Important
• Arrange the Basket Cloth and Basket Rod so they do not interfere with the Media Take-
up Sensor (indicated by the dotted line).
c
b
a
a
b
b
a
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
5
b
a
a