1.
Incident or reflected spot measuring
1.
To set for either incident or reflected light operation, turn the Incident / Reflected Spot Selector
Dial ⑲ on the eye piece, to the desired position (
Incident operation
2.
When incident operation is selected, the
Spot operation is selected the
Incident operation
NOTE:
• Before taking measurements, always make sure that the desired measurement mode
(
or
Dial is clicked in proper position.
• Do not rotate the Spot lens ring. There is danger of damage.
mark will blink for ten seconds on the LCD.
) is chosen by checking the LCD or that the Incident/Reflected Spot Selector
4. Basic Operation
or
mark) until it clicks.
Reflected Spot operation
mark will blink for ten seconds and when Reflected
Reflected Spot operation
-11-