Subscribe to Our Youtube Channel
Related Manuals for JL Audio PS-SWMCP
Summary of Contents for JL Audio PS-SWMCP
- Page 1 Installation Instructions for all PS-SWMCP swivel fixtures for flat surfaces SU R FACE M O U N T I N G FIX T U R E S (S W I V EL ) FOR PS650-V X™ ENCLOSED SPEAKER SYSTEMS...
- Page 2 Hand tighten one M6 x 16 mm Socket Cap Machine Partially thread the M6 x 20 mm Set Screw into the Screw and Split Lock Washer to temporarily secure the Mounting Receiver. Align the keys of the Mounting Mounting Base to the Fixture Base of the enclosure, as Base with the keyways in the Mounting Receiver, then illustrated.
- Page 3 Fixture Base. Slide a Split Lock Washer over Mounting Receiver. Remove adhesive backing and install each of three M6 x 16 mm Socket Cap Machine Screws, the JL Audio logo badge. apply Loctite® Red Thread Locking Compound to the screws, and fully tighten into the Fixture Base.
- Page 4 If you wish to rotate the speaker’s grille/logo badge Rotate the speaker to the desired angle. Reinstall the alignment, remove the six #8 x 1-1/4” speaker mounting speaker and speaker mounting screws and washers. screws and #8 Flat Washers. Hand-tighten in a criss-cross pattern. Steps 11-12 are for Standard Models Only Remove the backing from the rear logo appliqué.
- Page 5 Steps 13-14 are for Premium Models Only Clean the inside of the aluminum cap with acetone (not Align the aluminum logo cap to the desired angle of included) prior to attaching it to the enclosure. Apply a rotation, and press it onto the back of the enclosure. circular bead of silicone adhesive to the inside of the Apply masking tape (not included) to hold the cap in aluminum logo cap, 1/2-inch (13 mm) from the outer edge.
- Page 6 (hardware pictured for one) NOTE: The PS-SWMCP-B-SM Fixture and PS650-VeX-SG-TMB Enclosed Speaker System are used in this manual for illustrative purposes only. The fixture installation steps are the same for all PS650-VeX Enclosed Speaker Systems and all PS-SWMCP swivel fixtures for flat surfaces.
- Page 7 BOM ID Quantity Description Mounting Receiver M6 x 20 mm Set Screw #10 x 1” Flat Head Phillips Sheet Metal Screw M6 Split Lock Washer M6 x 16 mm Socket Cap Machine Screw Mounting Base Loctite® Red Thread-Locking Compound Silicone Adhesive Fixture Base #8 Flat Washer #8 x 1-1/4”...
- Page 8 . j l a u d i o . c o m JL Audio® and the JL Audio logo are registered trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.
Need help?
Do you have a question about the PS-SWMCP and is the answer not in the manual?
Questions and answers