Kenwood KHC29 Instructions Manual page 16

Hints and Tips
For best results store and juice the
l
fruit at room temperature and hand
roll on a worktop before juicing.
To help with juice extraction move
l
the fruit from side to side when
juicing.
When juicing large quantities,
l
empty the sieve regularly to
prevent the build up of pulp and
seeds.
Food Mincer
19
a
Ring nut
b
Screens: medium or coarse
(depends on model variant)
c
Cutter
d
Scroll
e
Body
f
Tray
g
Pusher
Assemble the Food Mincer as shown in
19
illustration
1 Fit the scroll inside the body.
2 Fit the cutter – ensure it is located
correctly with the cutting side
outermost.
3 Fit a screen – align the pin with the
notch.
4 Loosely fit the ring nut.
To use the Food Mincer
1 Raise the mixer head. Ensure both
outlet covers are fitted.
2 With the attachment in the position
shown - align the drive tabs on
the end of the scroll with the
corresponding slots in the drive
outlet.
3 Push the attachment into the outlet
and turn clockwise until it locks into
place.
4 Tighten the ring nut manually.
5 Fit the tray
6 Cut meat into 2.5cm (1") -wide strips.
7 Select Max speed. Using the pusher
gently push the food through, one
piece at a time. Do not push hard -
you could damage your machine.
Hints and Tips
Thaw frozen food thoroughly
l
before mincing.
Always ensure bones and rind etc
l
are removed from the meat before
mincing.
Juice Extractor
20
a
Pusher
b
Lid
c
Lid interlock tab
d
Filter
e
Pulp container
f
Juice outlet (spout)
g
Base unit
h
Pulp container release lever
i
Beaker
j
Beaker holder
Assemble the Juicer as shown in
20
illustration
1 Place the pulp container onto the
base unit and turn clockwise until it
locks into position. When correctly
fitted the juice outlet should be
located over the pulp container
release lever.
2 Fit the filter and push firmly into
position.
3 Fit the lid onto the pulp container -
turn clockwise to align the arrow
on the lid tab with the mark
base unit.
4 Place the beaker holder onto the
underside of the attachment – the
arrow
should be pointing upwards and
aligned with the juice outlet.
5 Whilst supporting the beaker holder,
fit the attachment to the outlet by
aligning the spout over the corner of
the machine and then turn clockwise
to lock into position.
6 To fit the beaker, rotate the holder
away from the spout and then place
the beaker in the holder. Rotate
the beaker so that it is located
underneath the juice outlet.
7 Cut the food to fit the food tube.
11
on the beaker holder
on the