Spray Cooling Unit (Optional Equipment); Temperature Range; Sawband Change - Behringer HBP530A-CNC Operating Instructions Manual

4.8.2 Spray cooling unit (optional equipment)

If the machine is equipped with a spray cooling unit, it is possible to switch over at the
control panel (menu "specific function" - page 13). This is recommend for thin walled
profiles that have nearly no chip amount. Technical hint take a look at appendix.

4.8.3 Temperature range

The coolant used by company Behringer is determined for a regular temperature range.
Under specific conditions (temperature below 0° C) w e recommend to use a suitable
coolant.
If necessary we preparing corresponding your conditions a specific offer.
Annotation: A use of the coolant with an additive of antifreezer is to avoid in case of health
problems. The combination of both are reacting ultimate toxic and are to use only in closed
systems.

4.9 Sawband change

Attention !
The sawing machine lags !
After switch off waiting until the machine stands still !
Never grip in the running tool !
The machine operates in a pull process, that means the tooth peak are showing in the
direction of the chip broach brush number 10; page 1a.
For changing the saw blade it is to do the following steps:
1. The machine is to switch in at the main switch. For an unlocked emergency cut-out it is
to switch in the hydraulic pump by pressing the function key "hydraulic on".
2. Saw frame lifting up by actuating the key „SR lift".
3. Opening the protection hood and hinge downward the chip broach brush
4. Switching off the hydraulic pump by the cut-out key.
Attention!
By the handling with the saw band it is to wear gloves!
5. The saw blade is completely to release with the manual wheel number 17, page 1a and
afterwards taking out the saw blade.
Important!
For every saw band change the both band guides have to cleaned
carefully.
Operating Instructions
HBP530A-CNC
Rev 07.02.11
Page 15
BA85308
Status 46/04