Saw Frame; Clamping Device; Material Collet; Supply Gripper - Behringer HBP530A-CNC Operating Instructions Manual

Operating Instructions
BA85308
Status 46/04
HBP530A-CNC

4.3 Saw frame

For lifting and lowering the sawframe it is necessary to actuate the function key "SR lift /
lower" (for "lifting" 2-hand operation). The sawframe is to lower so deep until the button
behind the sawband touches the sawing material. The lifting of the sawframe is also
possible by a switched on sawbanddrive. After the cut is finished the sawframe lifts up in
the automatic procedure over the material top edge. The distance between sawband and
material top edge is determined in the control procedure. During manual operation the
sawframe stays in his lowest position.

4.4 Clamping device

4.4.1 Material collet

The stationary attached vise is called material collet. To open or close the material collet
(for "clamp" 2-hand operation) is to do by the functiion key "MZ open / MZ clamp". During
the switch on of the sawbanddrive the material collet closed and clamps the material for
the whole sawing process.

4.4.2 Supply gripper

The vice which is attached at the supply carriage at the machine is called supply gripper.
The opening and closing (additional for clamping two hand operation) is to do by pressing
the corresponding function key "NG open" / "NG clamping".

4.4.3 Clamping pressure

For thin walled profiles it is possible to reduce the clamping pressure, that the fixed
material is not deformed. This adjustment is to do at the knurled screws at the pressure-
relief valve. The setted pressure is to read at the manometer.

4.4.4 Bunch clamping device (Optional equipment)

The bunch clamping serves for clamping several rods in different layers. It is mounted at
the gripping jaw or at the horizontal gripping jaw and connected with the hydraulic rapid
clutch. The clamping zone is to take out of the order confirmation.

4.4.5 Vertical vice (Optional equipment)

If the machine is equipped with a vertical vice, then the clamping devise is actuated with
the functions key "VS open and VS clamp" (for "clamp" 2-hand operation). The vertical vice
is only to clamp if it is active. The actuation does happened by the operation panel (see
menue page 13 special functions).. Just as the vertical vice is clamped by a switched on
drive motor.

4.4.6 Gantry vise (Optional equipment)

If the machine is equipped with a gantry vise, then the same is valid as for the vertical vise.
The gantry vise is also to activate before. The actuation does happened by the operation
panel. (see menue page 13 special functions).
Rev 07.02.11
Page 13