Instruction For Use; Rust Protection Paint; Coolant; Saw Band Choice - Behringer HBP530A-CNC Operating Instructions Manual

3 Instruction for use

3.1 Rust protection paint

The taper gibs of the clamping fixtures and all other guides have to be cleaned from the
rust protection paint by kerosene and lubricated before the first operation starts.

3.2 Coolant

It is to fill coolant in the coolant container. The volume that is to fill in can be read in the
technical data. We recommend B
mixture relationship of 1:5 to 1:10 with water. It is to make sure that the concentrate is
filled in the water and not vice versa. The mixing should be done by strong stirring.
If there is a danger of freezing it is additional to fill in anti-freezer (mixture relationship see
producer instructions).

3.3 Saw band choice

The dimensions of the saw band is to find out in the cover. For economical sawing we
recommend Behringer-HSS-Bimetal Saw bands with variable tooth pitch.
A relation of working length to tooth pitch is shown in the below chart :
working length
up to 100 mm
80-150 mm
120-220 mm
from 250 mm
We will gladly advice you for using specific sawblade qualities for different materials e.g.
hard alloy. Please consult our sales service or our agency.
Operating Instructions
HBP530A-CNC
EHRINGER
tooth pitch
4-6 TPI
3-4 TPI
2-3 TPI
1,4-2 TPI
Rev 07.02.11
Page 11
-High Speed-Coolant-Concentrate with an
BA85308
Status 46/04