Operation; Description Control Panel; Switch On And Off - Behringer HBP530A-CNC Operating Instructions Manual

4 Operation

A T T E N T I O N R I S K O F A C C I D E N T!
Never grip during a switched on machine in the clamping zone and in the
zone of the saw bow!
Always take care, that no one is in the working area of the tools (saw
band).
A T T E N T I O N
In manual mode it is important to pay attention, that no collision during
the different movements happen. The operation of the movements in
manual mode is the responsibility of the machine operator!!!!

4.1 Description control panel

Net control:
Shines white as soon as the main
switch is switched on and a
control voltage of 24 V is active.
Interruption
This illumining indicator shows a
interruption of the machine by a
red flashing.
Mode pre-selection
With this switch is pre-selected
between automatic- and manual
operation.

4.2 Switch on and off

The automatic sawing machine is switched on at the main switch. In the zero position the
switch can locked up with three padlocks. By pressing the emergency cutout the control
voltage is switched off and hence the machine is repealed. The unlocking of the
emergency cutout is to do by turning the red button. After the main switch is switched on
and the emergency cutoff is unlocked then the machine is to start in manual operation with
the function key "Hydraulic on". This is indicated by the LED. If the sawing machine did not
operate longer then approx. 15 minutes the control unit will switch off the hydraulic pump.
Operating Instructions
HBP530A-CNC
Rev 07.02.11
Page 12
Two hand operation
This key is used for several
operation tasks.
Point light *
With this switch is the point light
switched on respectively – off.
Roller train *
With this switch the actuated roller
trains are moved.
* = Optional equipment
BA85308
Status 46/04