Related Manuals for Pulsar V071
Summary of Contents for Pulsar V071
- Page 1 All manuals and user guides at all-guides.com CAL. V071, V072 ALARM CHRONOGRAPH ● Analogue time display ● Digital time and calendar ● Daily alarm ● 60-minute stopwatch ● Illuminating light...
-
Page 2: Screw Down Crown
All manuals and user guides at all-guides.com SCREW DOWN CROWN DISPLAY AND CROWN/BUTTONS [for models with screw down crown] Unlocking the crown 1 Turn Crown counterclockwise until you no longer feel the threads turning. 2 Crown can be pulled out. CROWN Digital display * The shape of the digital... -
Page 3: Time/Calendar Setting
All manuals and user guides at all-guides.com DIGITAL TIME SETTING TIME/CALENDAR SETTING ● Before setting the analogue time, be sure to set the digital time. CALENDAR SETTING Press to show TIME mode. Press to show CALENDAR mode. Press for 2 to 3 seconds. Press for 2 to 3 seconds. -
Page 4: Alarm Time Setting
All manuals and user guides at all-guides.com ANALOGUE TIME SETTING ALARM ● Before setting the analogue time, be sure to set the digital time. (See the previous section) ALARM TIME SETTING Second hand CROWN Hour Press to show ALARM mode. hand Minute 1 Pull out when the second hand is... - Page 5 All manuals and user guides at all-guides.com ALARM ENGAGEMENT/DISENGAGEMENT STOPWATCH ● The stopwatch measures up to 60 minutes in 1/100 second increments. With each press in ALARM mode, the alarm is engaged and disengaged alternately. Alarm Split / mark Split release / Reset * At the designated time, the alarm rings for 20 seconds.
-
Page 6: Illuminating Light
All manuals and user guides at all-guides.com Measurement of two competitors NOTES ON OPERATING THE WATCH TIME/CALENDAR SETTING FINISH TIME START FINISH TIME RESET [CALENDAR SETTING] OF 1ST COMPETITOR OF 2ND ● The calendar automatically adjusts for odd and even months except February of leap COMPETITOR FINISHES COMPETITOR... -
Page 7: Battery Change
● When the battery expires, be sure to replace it as soon as possible to prevent any malfunction. STOPWATCH ● We recommend that you contact an AUTHORIZED PULSAR DEALER for battery replacement. ● With each press of button C, the light illuminates the digital display with a beep. -
Page 8: Water Resistance
● Water resistance (10 bar/15 bar/20 bar)* ● Never short-circuit, tamper with or heat the battery, and never expose have it checked by an AUTHORIZED PULSAR If “WATER RESISTANT 10 BAR”, it to fire. The battery may burst, become very hot or catch fire. - Page 9 All manuals and user guides at all-guides.com * Before using the water resistance 5, 10, 15 or 20 bar watch in water, be sure the MAGNETISM SHOCKS & VIBRATION crown is pushed in completely. Do not operate the crown when the watch is wet or in water. If used in sea water, The analogue unit of your Light activities will not rinse the watch in fresh water and dry it completely.
-
Page 10: Periodic Check
2 to 3 years. Have sticker on the case back, your watch checked be sure to peel them off by an AUTHORIZED PULSAR before using your watch. DEALER or SERVICE CENTER to ensure that the case, crown, buttons, gasket and crystal seal remain intact.
Need help?
Do you have a question about the V071 and is the answer not in the manual?
Questions and answers