Lamp Replacement - Sanyo PLC-XF41 Owner's Manual

APPENDIX
Follow these steps to replace lamp assembly.
1
Check number of lamp to be replaced on Lamp Status Display.
Turn off a projector and disconnect AC Power Cord. Allow a
2
projector to cool down for at least 45 minutes.
3
Remove two screws on Lamp Cover and press button to open
Lamp Cover. (See right figure.)
4
Loosen two screws and pull out Lamp Assembly to be replaced
by grasping handle.
5
Replace Lamp Assembly with a new one and tighten two screws.
Make sure Lamp is set properly
6
Replace Lamp Cover and tighten two screws.
7 Connect AC Power Cord to a projector and turn a projector on.
8 Reset Lamp Replacement Counter. (Refer to section "Lamp
Counter Reset" on page 42.)
NOTE : Do not reset LAMP REPLACEMENT COUNTER when
lamp is not replaced.
46