Configurations Of Terminals - Sanyo PLC-XF41 Owner's Manual

DVI-I TERMINAL (DIGITAL/ANALOG)
This terminal accepts only Digital (TMDS) or Analog (RGB) output signal. Connect display output terminal of computer to
this terminal with DVI cable (supplied).
C1 C2
1 2 3 4 5 6 7 8
9 10 11 12 13 14 15 16
17 18 19 20 21 22 23 24
C3 C4
C5
HDB 15-PIN TERMINAL (ANALOG)
Connect display output terminal of computer to this terminal with VGA Cable (supplied).
G When connecting Macintosh computer, use MAC/VGA Adapter (supplied).
G When connecting Analog signal from DVI terminal of computer to this terminal, use DVI/VGA Adapter (supplied).
Pin Configuration
5 4 3 2 1
10
9 8 7 6
15
14 13 12 11
CONTROL PORT CONNECTOR
Terminal : Mini DIN 8-PIN
Connect control port (PS/2, Serial or ADB port) on your computer to this terminal with Control Cable (supplied).
Pin Configuration
8 7 6
5 3
4
2 1

CONFIGURATIONS OF TERMINALS

T.M.D.S. Data2–
No Connect
1 Red Input
2 Green Input
3 Blue Input
4 Sense 2
5 Ground (Horiz.sync.)
6 Ground (Red)
7 Ground (Green)
8 Ground (Blue)
PS/2 Serial ADB
1 ----- R X D -----
2 CLK ----- ADB
3 DATA ----- -----
4 GND GND GND
5 ----- RTS -----
6 ----- T X D -----
7 GND GND -----
8 ----- GND GND
9 +5V Power
10 Ground (Vert.sync.)
11 Sense 0
12 DDC Data
13 Horiz. sync.
14 Vert. sync.
15 DDC Clock
APPENDIX
51