Setting-Up Projector; Connecting Ac Power Cord - Sanyo PLC-XF41 Owner's Manual

PREPARATION
This projector uses nominal input voltages of 100-120 V
or 200-240 V AC. This projector automatically selects
correct input voltage. It is designed to work with single-
phase power systems having a grounded neutral
conductor. To reduce risk of electrical shock, do not plug
into any other type of power system.
Consult your authorized dealer or service station if you
are not sure of type of power supply being in use.
Connect a projector with peripheral equipment before
turning a projector on. (Refer to pages 12 ~ 15 for
connection.)
NOTE ON POWER CORD
AC Power Cord must meet requirement of country where you use a projector.
Confirm AC plug type with chart below and proper AC power cord must be used.
If supplied AC Power Cord does not match AC outlet, contact your sales dealer.
Projector side
To POWER CORD
CONNECTOR on a
projector.
8

SETTING-UP PROJECTOR

CONNECTING AC POWER CORD

For the U.S.A. and Canada
Ground
To the AC Outlet.
(120 V AC)
Connect AC Power Cord (supplied) to
a projector.
AC outlet must be near this equipment
and must be easily accessible.
AC Outlet side
For Continental Europe
To the AC Outlet.
(200 - 240 V AC)
For the U.K.
To the AC Outlet.
(200 - 240 V AC)