Table of Contents
Advertisement
Before calling your dealer or service center for assistance, check matters below once again.
1. Make sure you have connected a projector to your computer or video equipment as described in section "CONNECTING
PROJECTOR" on pages 12 ~ 15.
2. Check cable connection. Verify that all computer, video and power cord are properly connected.
3. Verify that all power is switched on.
4. If a projector still does not produce an image, re-start your computer.
5. If an image still does not appear, unplug a projector from your computer and check your computer monitor's
display.Problem may be with your graphics controller rather than with a projector. (When you reconnect a projector, be
sure to turn a computer and monitor off before you power up a projector. Power equipment back on in order of : Projector
and computer.)
6. If problem still exists, check following chart.
Problem:
No power.
Image is out of
focus.
Picture is Left/Right
reversed.
Picture is
Top/Bottom
reversed.
Some displays are
not
seen
during
Operation.
No image.
No sound.
TROUBLESHOOTING
G Plug a projector into your AC outlet.
G Turn MAIN ON/OFF switch to ON.
G Press POWER ON/OFF switch to ON.
G Make sure READY Indicator lights.
G Wait 90 seconds after a projector is turned OFF when turning a projector back on.
NOTE : After pressing Power ON-OFF button to OFF, make sure a projector works as
follows:
1. LAMP indicator lights bright and READY indicator turns off.
2. After 90 seconds, READY indicator lights green again and a projector may be
turned on by pressing Power ON-OFF button.
G Check WARNING TEMP. and READY indicator. If both WARNING TEMP. and READY
indicator flashes, a projector cannot be turned on.
(See "TURNING ON/OFF PROJECTOR" section on page 21.)
G Check Projection Lamp. (Refer to page 45.)
G Adjust focus of a projector.
G Check Projection Lens to see if it needs cleaning.
NOTE : Moving a projector from a cool temperature location to a warm temperature location
may result in moisture condensation on Projection Lens. In such an event, leave a
projector OFF and wait until condensation disappears.
G Check Ceiling / Rear feature. (See "SETTING" section on page 39.)
G Check Ceiling feature. (See "SETTING" section on page 39.)
G Check Display feature.(See "SETTING" section on page 39.)
G Check connection between your computer or video equipment and a projector.
G When turning a projector on, it takes about 30 seconds to display an image.
G Check system that you select is corresponding with your computer or video equipment.
G Make sure temperature is not out of Operating Temperature (5°C ~ 35°C).
G Check audio cable connection from audio input source.
G Adjust audio source.
G Press VOLUME (+) button.
G Press MUTE button.
Try these Solutions
APPENDIX
47
Advertisement
Table of Contents
