Output Mode Of Received Data - Ebyte JN5189 User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd.
E180-Z8910SP User Manual
5.1.5 Protocol unicast mode
When the sending device is in transmission mode, the serial port receives data. The first two bytes represent the short
address of the target network, and the following data represents valid wireless transmission data. There is no need to
enter the configuration mode to configure the short address of the target network.
Note: When configured as broadcast or multicast, the period of periodic transmission is recommended to be greater than
or equal to 500ms, otherwise it may cause data congestion.

5.2 Output mode of received data

The received data output mode refers to the way in which the serial port outputs data after the module receives wireless
data;
5.2.1 Transparent output
If the output mode of the configuration device is transparent output, the module will output the original data through the
serial port after receiving the wireless data;
5.2.2 Data + short address
When the output mode of the device is data + short address, after the module receives wireless data, the serial port will
output the original data + the short address of the sending device;
5.2.3 Data + Long Address
This product does not support this output mode.
5.2.4 Data + RSSI
When the output mode of the device is data + RSSI, after the module receives the wireless data, the serial port will output
the original data + the RSSI value of the received data packet;
5.2.5 Data + short address + RSSI
When the output mode of the device is data + short address + RSSI, after the module receives the wireless data, the serial
port will output the original data + the short address of the sending device + the RSSI value of the received data packet;
5.2.6 Data + Long Address + RSSI
This product does not support this output mode.
Copyright ©2012–2021，Chengdu Ebyte Electronic Technology Co.,Ltd.
14