Receive Data Output Mode; Network Node Type - Ebyte JN5189 User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd.

6.5.2 Receive data output mode

Read command format:
Command format
Send: FE 01 26 FF
Return: FB 27 out_mode
Configuration instruction format:
Command format
Send: FD 01 27 mode FF
Return: FA 27
mode:
0x00 transparent transmission (default);
0x01 data + short address;
0x03 data+RSSI;
0x04 data + short address + RSSI;
Note: The sender supports a single packet with a maximum data packet length of 82 bytes

6.5.3 Network node type

Read command format:
Command format
Send: FE 01 01 FF
Return: FB 01 dev_type
Configuration instruction format:
Command format
Send: FD 01 01 dev_type FF
Return: FA 01
dev_type:
The configuration of changing the node type needs to be restarted to take effect. In normal operation, the device
configured with the node type will leave the current network in a non-network state, and will switch to the changed node
type after restarting. The dormant terminal supports the wake-up function of the serial port receiving pin. The first frame
of data sent by the serial port during sleep is the wake-up frame. It is recommended to use the 5-byte "FF" to wake up
"FF FF FF FF FF".
Copyright ©2012–2021，Chengdu Ebyte Electronic Technology Co.,Ltd.
0x03 terminal (default)
0x04 Sleep terminal
Command example
Send: FE 01 27 FF
Return: FB 27 00
Command example
Send: FD 01 27 00 FF
Return: FA 26
Command example
Send: FE 01 01 FF
Return: FB 01 03
Command example
Send: FD 01 01 03 FF
Return: FA 01
E180-Z8910SP User Manual
25