Remote Control Battery Installation; Using The Remote Control Unit - Sanyo PLC-SP20N Owner's Manual

1
Remove the battery
compartment lid.

USING THE REMOTE CONTROL UNIT

Point the remote control toward the projector (Receiver window) whenever pressing the buttons. Maximum operating range
for the remote control is about 16.4' (5m) and 60° front and rear of the projector.
To insure safe operation, please observe the following precautions:
¡Use (2) AA type alkaline batteries.
¡Change two batteries at the same time.
¡Do not use a new battery with a used battery.
¡Avoid contact with water.
¡Do not drop the remote control unit.
¡If batteries have leaked on the remote control, carefully wipe the case clean and load new
batteries.

REMOTE CONTROL BATTERY INSTALLATION

2
Slide the batteries into the
compartment.
Note: For correct polarity (+ and –
terminal), be sure the battery
terminals are in contact with
the pins in the compartment.
16.4'
(5 m)
60°
– 23 –
3
Replace the compart-
ment lid.
16.4'
(5 m)
60°