1.7 Instructions for use ....29 General This Workshop Manual is intended for Stiga Park models 2000-2007. The article numbers and product names are designated in the tables under “Technical specification” at page 21. This Manual do not cover repair instructions for the motors. Regarding motors, contact the respective representative in the actual country.
Edition Manual Chapter Page 2008-05-19 Workshop Manual, Stiga Park 1 General instructions 1.1 Introduction 1.1.1 Responsibility declaration In spite of the great care we have taken there may be errors in this publication. The author cannot be made liable for incorrect or missing information.
Edition Manual Chapter Page 2008-05-19 Workshop Manual, Stiga Park 1 General instructions 1.2.1 Symbols and general 1.2.5 Cleanliness warnings Clean the machine before starting repairs. Warning! Dirt that penetrates into sensitive components can seriously influence the This symbol indicates a risk of service life of the machine.
Edition Manual Chapter Page 2008-05-19 Workshop Manual, Stiga Park 1 General instructions 1.3 Guarantee 1.3.1 Guarantee period 1.3.4 Exeptions For consumer use: two years from date of The extended warranty does not cover purchase. damage due to the following: For professional use: 200 hours or three •...
Edition Manual Chapter Page 2008-05-19 Workshop Manual, Stiga Park 1 General instructions 1.4 Unpacking and assembly Every Stiga Park has undergone an extensive control programme before delivery. The machines are delivered as completely assembled as possible. Thanks to this the assembly on delivery is rapid and easy.
Edition Manual Chapter Page 2008-05-19 Workshop Manual, Stiga Park 1 General instructions 1.4.2 Battery The battery can be of the following two types, depending on tha actual machine: • Valve regulated type (A) • Dry charged type (B) Depending on the battery type, load and assemble the battery, following the actual instruction below.
Page 8
Edition Manual Chapter Page 2008-05-19 Workshop Manual, Stiga Park 1 General instructions Dry charged battery Dry charged batteries are delivered without battery acid in their cells. Warning! Filling with battery acid shall take place in a well illuminated and ventilated place with rapidly access to fluiding water for rinsing.
Edition Manual Chapter Page 2008-05-19 Workshop Manual, Stiga Park 1 General instructions 1.4.3 Assembly The assembly procedure shall take place in a clean, well illuminated and dry place. Assemble the machine as follows: Assembly of steering wheel Instructions for machines with mechanic...
Page 10
Edition Manual Chapter Page 2008-05-19 Workshop Manual, Stiga Park 1 General instructions Assembly of seat (adjusting knobs under) Install the mounting in the rear (upper) holes as follows: 1. Install the shoulder washers (E) on the screws (F). 2. Insert the screws through the slots in the bracket.
Page 11
Edition Manual Chapter Page 2008-05-19 Workshop Manual, Stiga Park 1 General instructions If the screws are tightened more than 9±1.7 Nm, the seat will be damaged. 4. Check that the seat moves easily in the slots in the bracket. Install the mounting in the front (lower) holes as follows: 1.
Page 12
Edition Manual Chapter Page 2008-05-19 Workshop Manual, Stiga Park 1 General instructions Arm rest (if applicable) The arm rests and the installation components are supplied in a separate box. Assemble as follows: 1. Assemble the left and right mounts onto the seat.
Edition Manual Chapter Page 2008-05-19 Workshop Manual, Stiga Park 1 General instructions 1.4.4 Final checks Removing from pallet Steering chain / Steering wire Check that the steering chain / steering All the above measures shall have been done with the machine standing on the pallet. Now, wire is sufficiently taut.
Manual Chapter Page 2008-05-19 Workshop Manual, Stiga Park 1 General instructions 1.5 Service Every new machine is delivered with a service book. This service book is part of the active post-market programme and shall be kept in a safe place during the entire lifetime of the machine.
Edition Manual Chapter Page 2008-05-19 Workshop Manual, Stiga Park 1 General instructions 1.5.1 First Service 1.5.2 Intermediate Service The first service shall be performed within 5 The intermediate service shall be conducted hours of running and includes the service between two basic services. That means: points as per the table below.
Page 16
Edition Manual Chapter Page 2008-05-19 Workshop Manual, Stiga Park 1 General instructions 1.5.3 Basic Service The basic service shall be conducted as follows: For Pro Diesel: Every 200 hours or every year, which first occur. For all other machines:Every 100 hours or every year, which first occur.
Edition Manual Chapter Page 2008-05-19 Workshop Manual, Stiga Park 1 General instructions 1.5.4 Description of service points 1. Safety check Check the safety functions. It is often appropriate to do this check in conjunction with test driving. The following items shall be checked at all machines: •...
Page 18
Edition Manual Chapter Page 2008-05-19 Workshop Manual, Stiga Park 1 General instructions Royal and Pro 16, electrical safety check Test Status Action Result Brake pedal not pressed. Turn the key and make a Motor shall not PTO not activated. start attempt.
Page 19
Edition Manual Chapter Page 2008-05-19 Workshop Manual, Stiga Park 1 General instructions Pro Diesel, electrical safety check Test Status Action Result Brake pedal not pressed. Turn the key and make a Motor shall not PTO magnetic clutch not activated. start attempt.
Page 20
Edition Manual Chapter Page 2008-05-19 Workshop Manual, Stiga Park 1 General instructions 2 Tyres, air pressure 11 Spark plug Check the air pressure. Adjust if necessary. Remove the spark plug (not valid for Pro The recommended air presure is Diesel) and clean it or replace if necessary.
Need help?
Do you have a question about the Park 2/4WD and is the answer not in the manual?
Questions and answers