Use Of Telnet - Sanyo POA-PN01A Owner's Manual

Controlling External Equipment

Use of Telnet

The following is a control example of external equipment connected to this product
by using the telnet application*
needed to use commands*
Preparation
1
Disconnect AC plug from the projector and connect an external equipment to the
extra serial port with an RS-232C serial cable.
2
Turn the projector and external equipment on.
3
Display the "Extra Serial Port Setting" page with the web browser. ( refer to page 57).
4
Change the serial port setting to be the same communication condition as the con-
nected external equipment and then press the Set button.
The following example setting is for our projector communication condition. When
controlling our projector set as follows
Baud rate
Parity
Stop
Flow Control
Data
Port
Control
(For example, in case of using the Telnet application in the Windows 98.)
1
Select the Run... submenu from the Start menu on the computer. Type "telnet" onto the
Open text area on the displayed window and press the OK button.
2
Launch the telnet application and the following window will be displayed. Select
the Remote System from the Connect pulldown menu.
*1 Further instructions about the telnet application, please see the on-line guide on your com-
puter. Macintosh does not provide the telnet application.
*2 The commands are defined by each product independently, so please consult the manufac-
turer or sales dealer for further information of the commands.
58
1 installed on your computer. The telnet application is
which controls the external equipment.
2
:
19200
NONE
1
NONE
8
23