Table of Contents
Advertisement
How to enter the numbers
To move the selection and change the values, Use the pointers
projector or on the remote control handset.
The
/
The
/
keys are used to change the number value.
3
Restart the Network board
Press the SELECT button again. The network configuration display disappears
and the network board begins restarting*
connect the AC cord from the projector.
Completing of installation
Now the installation is completed. The IP address of this projector was set to
"192.200.1.201". Next, please see chapter "Basic setting and operation" on page
25. It describes basic setup and operation of the projector.
Password setting menu [Display]
A password can be set to restrict access to the setting pages of the projector using
the web browser. The default password is set "0000" as no password.
Use the projector's menu and select the Display icon on the Setting sub menu, and
then press the SELECT button on the projector twice. The following setting display
appears on the screen. The numbers on the display indicates the current password.
To change the password, enter your desired number by using the pointers on the
projector or remote control handset, and then press the SELECT button. The pass-
word setting display disappears and the network board begins restarting*
about 60 seconds. Do not disconnect the AC cord from the projector.
*1 The network board begins restarting automatically when the network configuration or pass-
word setting is changed and pressing the SELECT button. After the power indicator turns
off twice, and it lights continuously. This indicates that restarting is completed and it takes
about 60 seconds.
Password setting must be done when you connect the projector to the network. This setting
is carried out through the projector's menu and also it can be set through the network using
the web browser. For further information please refer to chapter "Initial Setting/Password
setting" on page 29.
Valid characters for password are only numeric numbers 0 to 9.
This password is not to restrict the use of the projector. This password is to set the security
against the use of the projector through the network.
keys are used to move the selection item.
Password
0
1
. It takes about 60 seconds. Do not dis-
0
0
0
Network configuration
/ /
/
on the
1
. It takes
PJ-Net Organizer
OWNER'S MANUAL
17
Advertisement
Table of Contents
