Notice About System Construction - Sanyo POA-PN01A Owner's Manual

Installation

Notice about system construction

For installation of multiple projectors into the same network with PJ-Net
Organizer.
Do not install multiple projectors with PJ-Net Organizers that have their default net-
work settings to the same network. The use of the PJ-Net Organizers which have the
default IP address set to the same network settings will cause IP addresses to collide
and create a malfunction. When you install multiple projectors into the same net-
work, configure the network with the following steps.
1. Change the IP address from the default IP address. To change the IP address, use
the network setting menu on the projector. Please see chapter "Network
Configuration" on page 15 for further information.
2. Make sure that there is no network equipment set with the same IP address in the
network, and then connect to the network.
3. When installing other projectors, follow the above steps to change the IP address
and connect to the network.
In case of installing the projector with PJ-Net Organizer into the net-
work constructed with the DHCP/BOOTP server.
This PJ-Net Organizer does not support the DHCP/BOOTP server. The static IP
address must be configured by the manual. To use this product in this network envi-
ronment, set it up so that the DHCP/BOOTP server does not assign the IP address
configured to this product for another device on the network. Please consult your
network administrator for further information.
24