Service - Sanyo POA-PN01A Owner's Manual

Service

This function sets parameters for service items of the projector. As these
service items are used mainly for maintenance, please use the default set-
ting unless a change is needed. The adjustments and operation are listed
below. To restore to default setting, press the Initialize button.
Adjustments
Fan Control Speed
Video System*
Horizontal*
Vertical*
Position*
* These items are available in the video input mode for models PLC-XP41
The adjustments of Visual Area and Position are effective only for video input mode. These
adjustment values are stored with each video system mode as the above.
Operation
Select the Max or Normal with radio buttons and then press the Set but-
ton.
It displays the current selected video system. The video systems and
displays are listed below.
Adjust the valid horizontal width with the + and - buttons.
Adjust the valid vertical height with the + and - buttons.
Adjust the screen position with the Up, Down, Left and Right buttons.
series and PLC-XP46 series only.
- The indication of video system in this page is displayed as follows.
Video System
480I
480P
575I
575P
720P
1035I
1080I
Input Signal
NTSC [VIDEO], [S-VIDEO], [Y, Cb/Pb, Cr/Pr]
NTSC [Y, Cb/Pb, Cr/Pr]
PAL [VIDEO], [S-VIDEO], [Y, Cb/Pb, Cr/Pr]
PAL [Y, Cb/Pb, Cr/Pr]
[Y, Pb, Pr]
[Y, Pb, Pr]
[Y, Pb, Pr]
Control the projector
PJ-Net Organizer
OWNER'S MANUAL
45