Table of Contents
Advertisement
4.1 - Mode I
In Mode I the command associated with the transmitter keys is fixed (table A1). In Mode I only one memorisation phase is performed for each
transmitter and only one memory location is occupied. During memorisation in Mode I it is not important which key is pressed on the transmitter.
Table A1 - Memorisation using Mode I
Key
Key s or 1st channel
Key n or 2nd channel
Key t or 3rd channel
4th channel
4.2 - Memorising transmitters in Mode I
When there is no transmitter memorised, the first can be memorised during startup according to the following procedure.
Table A2 - Memorising first transmitter during startup in Mode I
01. Connect the control unit to the power mains, confirmed by 2 red flashes.
02. Within 10 seconds:
Monodirectional transmitters: press and hold and key of the transmitter to be memorized for at
•
least 3 seconds.
•
Bidirectional transmitters: press any key of the transmitter to be memorized
03. If the memorisation procedure is successful, the LED emits 3 red flashes.
If no transmitters should be memorized during startup, the programming procedure concludes automatically after 10 seconds and the LED
emits one long red flash.
The transmitters can be memorised using the programming pushbutton according to the following procedure.
Table A3 - Memorising first and other transmitters in Mode I
01. Press and hold the programming pushbutton (fig. 1).
02. Release the programming pushbutton (fig. 1) when the LED illuminates with red color (1st position).
03. Within 10 seconds:
Monodirectional transmitters: press and hold and key of the transmitter to be memorized for at
•
least 3 seconds.
•
Bidirectional transmitters: press any key of the transmitter to be memorized
04. If the memorisation procedure is successful, the LED emits 3 red flashes.
05. Repeat steps 3 and 4 to acquire all the remotes.
06. After 10 seconds that the device doesn't receive any signal, the programming procedure concludes
automatically.
If transmitters have already been memorised, other transmitters can be memorised as described in the following procedure.
Table A4 - Memorising other transmitters with a previously memorised transmitter in Mode I
01. Press any key three times of a previous, memorised transmitter.
02. Press the same key three times of a new transmitter.
03. Press the same key three times of a previous, memorised transmitter.
04. Press the same key of the new transmitter.
05. If the memorisation procedure is successful, the LED emits 3 red flashes.
06. The programming procedure concludes automatically.
Note. If the memory is full (30 transmitters memorised) 6 red flashes are emitted and the transmitter cannot be memorised.
Command
Toggle output 1
Toggle output 2
–
–
Example
MONO:
3s
BIDI:
Example
MONO:
3s
BIDI:
Example
Old
x3
New
x3
Old
x3
New
Advertisement
Table of Contents
