Page 2
These instructions should be used to aid installation of the following products: RW6WW / RW6CW / RW6CCT SAFETY • This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671) and current Building Regulations.
Page 3
• This product is IP65 rated INSTALLATION INSTALLATION Note: If this luminaire is being used in conjunction with external PIR or sensors, pleas the manufacturer of the sensors that they are compatible with LED luminaires. Note - If this product is being used in conjunction with an external PIR or sensor, please confirm with the manufacturer of the sensors that they are compatible with LED luminaires.
Page 4
block (see Fig 2) • With the aid of a cross-head screwdriver, remove the cover to access the mains terminal block (see Fig. 2) Fig 2 Fig. 2 • Connect the luminaire to the mains supply ensuring that correct polarity is observed •...
Page 5
STABLE CCT FITTING ONLY (RW6CCT) • Lift both of the spring clips on the sides of the fitting and push into the ceiling • Switch on and check for correct operation COLOUR CHANGE ADJUSTABLE CCT FITTING ONLY (RW6CCT) To change the colour temperature of the fitting, switch the fitting on, off and on again 2 seconds.
Page 6
ML Accessories does not accept responsibility for any installation costs associated with the replacement product. Your statutory rights are not affected. ML...
Page 7
MEMORY FUNCTION • The luminaire will always remain the same colour temperature until the above switching cycle has been carried out RESET FUNCTION • To reset the fittings back to warm white, turn on the fittings and leave them on for 5 seconds •...
Page 8
INTERNAT CONTACT D INTERNATIONAL CONTACT DETAILS ML Accessories Limited LU5 4LT www.mlaccessories.co.uk DCJUL21_V4...
Need help?
Do you have a question about the RW6WW and is the answer not in the manual?
Questions and answers