for Waterproof Digital Thermometer Model SK-270WP
Thank you for purchasing the S270WP series optional probes.
- These probes are designed to measure temperature connecting with SK-270WP series Waterproof Digital
Thermometers. Do not use it for other purposes.
- Read this manual thoroughly before using. Keep the manual in a safe place for future references whenever
necessary.
Parts and Names
Model S270WP-21 Sleeve type probe
① Sensing part
② Sleeve
③ Cord
④ Sensor connector
Model S270WP-31 Immersion type probe
① Sensing part
② Cord
③ Sensor connector
How to Use
1. Installing Probes
While the main unit is turned off, insert the probe connector into the unit by aligning the probe connector with the
connector on the unit.
Turn the nut of the sensor connector clockwise to secure the probe.
To disconnect the probe, turn the nut counterclockwise and pull the sensor connector straight out.
Cautions
Be sure to observe the following precautions in order to use this unit correctly.
- These probes are designed for SK-270WP series Waterproof Digital Thermometers. Do not connect them to the
other thermometers.
- Be sure to use these probes within the specified measurement range. Using it outside the specified
measurement range will result in failure or damage.
- These probes are made of stainless steel. Be careful not to burn yourself.
(For S270WP-21) At the measurement of high temperature object, get the length 15 times of the stem diameter
or more away from the measuring object. (ex. when the diameter is 3mm, get at least 45mm away from object)
Instruction Manual
S270WP Series Optional Probes
NB: - To protect the temperature probe, make sure that
the unit is turned off before installing or removing
the probe.
- Do not install or remove the probe with a wet hand.
Need help?
Do you have a question about the S270WP Series and is the answer not in the manual?
Questions and answers