Advertisement
Step 2
Attaching the Base
+ 5-point Harnesses
A
Point backward towards the back of the Canopy
1
Place Base (3) in the bottom, inside the Canopy
Point forward towards the headtube of the Bullitt
B
1
2
Align bolts with holes in the
1
back (1) and in the center (2) of
the Honeycomb Board.
Attach the 5-point Harnesses
3
to the buckles in the bottom.
Fold them forward/up, so you can
see what you are doing next.
Mount the 2 bolts (from the back
5
/outside of the Canopy) to the
tubes (1). Add washers to the 2 bolts.
Grease bolts.
5
Note! Make sure the seat belt
2
buckles point inwards (under-
neath the foamy part) before
attaching the bolts.
Grease your center bolt and
4
mount it in the bottom center
loosely so you can align the rest.
x2
Tighten the nuts, so the Twin Seat
6
tubes sits closely to the frame.
Tighten the center bolt too.
5-6 Nm
Advertisement
