Klarstein CLARA Manual page 36

EN
36
Replacing the lamp
1. Switch off the device immediately and pull the power plug out.
2. Open the glass cover and remove the grease filter. Put one hand into the
cavity and carefully push out the LED light. Pull the light out from the outside
with another hand. Dismantle the lamp cable connector and remove the lamp.
3. When installing the new lamp, proceed in reverse order.
Max.
Voltage
power
2 x 1.5 W DC 12 V
Replacing the colour LED light strip
1. Open the glass cover.
2. Remove the control box cover and the lamp holder with a screwdriver.
3. Dismantle the clamp of the light connecting wire and replace the lamp.
LED
Dimensions:
modules
Round
lamp
ILCOS D
code
DSR-1.5/
65-S-64