Table of Contents
Advertisement
2
11.5 Removing the footrests
• Remove or fold up the seat. Then, raise the foot-
rest by approx. 100 mm and turn outwards by 90
degrees.
• Now you can push the footrest all the way up and
pull it out
11.6 Handling of the toilet bucket
• From the back of the chair, slide the toilet bucket
under the seat. To remove, slightly lift the bucket
and then pull it out backwards.
• In the version with a 2-section toilet seat, you can
alternatively insert or remove the toilet bucket from
above by lifting the seat.
11.7 Removing the backrest cushion
• For cleaning purposes or for
replacement
cushion can be removed from
the arresting grid at the
backrest of the chair by press-
ing against it with your hand
from the back.
12 Troubleshooting
Fault
Potential cause
Armrest can-
Deposits in the
not be swiv-
locking device
elled down
(locking bolt)
Locking bolt
Deposits, tension
cannot be
spring jammed or
pulled out
defective
Footrest can-
Deposits in the
not be folded
joint,
down
Bracing
Wheel lock
General defect
does not brake
Turning the
Deposits
wheel is stiff
Wheel does
General defect
not turn
BA-Nr.: 02.07.142/2021-12-A01
REBOTEC /
Fault
1
Uneven run-
ning of the
wheel
Chair frame
too unstable
Wheel insert
bent/distorted
13 Care and maintenance
13.1 Cleaning and care
• Do not use scouring agents or cleaning agents
the
backrest
• The product is suitable for manual cleaning and
13.2 Maintenance
• Wear and tear that is not recognised in time and/or
Remedy
Cleaning,
checking
• Check product for visible damage
regularly
Cleaning,
Replace
• Check stability before use
the locking
bolt
Maintenance/inspection scope
Cleaning,
Check
screw con-
nection
see mainte-
nance!
Cleaning
see mainte-
nance!
- 8 -
Potential cause
Severe uneven
tread wear
Screw connections
too loose
Hitting an obstacle
The product can be cleaned using a mild
conventional
cleaning
agent. After cleaning, wipe the product with a clean,
moist cloth and then wipe it dry with a dry cloth.
with aggressive ingredients (acids, thinners), as
well as hard cleaning objects (brushes), as other-
wise the surfaces may be damaged or deposits
may form on the materials.
Keep the product clean and clean it regu-
larly. Special attention must be paid to hy-
giene in the sensitive areas.
disinfection. Please observe the reprocessing in-
structions (02.12.156).
improper handling, as well as irregular or no
maintenance may result in accidents.
For safety reasons, the product must be pro-
fessionally maintained at least once a year.
(Cracks, breakage, loose parts)
• Maintenance should include the following in-
spection work and should be documented.
• All bolted connections for tightness (espe-
cially the wheel inserts and the frame)
• Function of the armrests and locking bolts
• Function of the footrest (replace defective
footrests)
• Running characteristics and tread of the
wheels (replace defective wheels)
EN
Remedy
see mainte-
nance!
Screw con-
nections:
Tighten
frame,
wheel in-
serts
see mainte-
nance!
and
disinfecting
Advertisement
Table of Contents
