Advertisement
4
Place the guide bar on the
STEP 4:
bar pad by sliding the bar slot over the
alignment flange, with the mounting
stud inserted through the slot in
the guide bar (A). Align the lower
tensioning hole on the guide bar to
seat on the tensioning stud (B).
5
RED
B
A
A
STEP 5:
Install the side cover, making
sure the chain catcher and side
cover tabs are seated in their proper
locations (A), then lightly tighten the
side cover knob (B). Do NOT fully
tighten at this stage.
6
RED
B
A
Adjust chain tensioning dial
STEP 6:
(A) then fully tighten the side cover
knob (B).
All manuals and user guides at all-guides.com
CS1200 CHAINSAW
Quick Start Instructions
TENSIONING THE SAW CHAIN
ATTENTION!
SAFETY NOTICE
Unplug the chainsaw
A
Loosen the side cover release
STEP 8:
knob slightly, but do not remove the
B
side cover.
STEP 9:
Hold up the nose of the guide
bar (A) and turn the chain tensioning
ring clockwise.
STEP 10:
Tighten the chain tensioning
ring until the lowest cutters
underneath the bar solidly contact the
bar (B).
8
WARNING
An electric power tool that is plugged in can start accidentally.
Unplug the chainsaw before preparing for use or performing maintenance.
WARNING
If the chain is still loose when the saw is at maximum tension, replace
the chain.
Only tension the saw chain when the chain is cool.
IMPORTANT
INCORRECT
STEP 11:
Lightly pull on the chain. The tension is correct when the chain snaps back
after being pulled 3 mm away from the guide bar.
STEP 12:
After a short period of use, allow the chain to cool, unplug the chainsaw
and check the tension again. Watch tension carefully for the first half-hour of use and
periodically throughout the life of the chain readjusting as required when the chain
and bar are cool to the touch. Never tension chain when it is hot.
Chain will stretch as a result of normal use, however, insufficient oil, aggressive use,
or failure to perform recommended maintenance can lead to premature stretching.
IMPORTANT: The saw chain must be
properly tensioned before using.
ATTENTION!
Wear Chainsaw Protective Gloves
9
10
BLACK
B
SAFETY NOTICE
A
B
CORRECT
Advertisement
