Safety Instructions - probst AIRLIFT ALX-120 Operating Instructions Manual

Safety instructions

3 Safety instructions
It is the responsibility of the operator to test the loads used to ensure safe handling of the loads. Due to
the large number of optional suction plates, the load capacity (WLL) indicated on the respective suction
plate must always be observed and must not be exceeded under any circumstances!
The following aspects must always be observed / taken into account before and during operation:
•
Density of the actual load being lifted. The densities vary even with the same layer of concrete
produced.
•
Use the correct size suction plate. (it should always be tested with the largest suction plate that fits the
surface).
•
Condition of the suction plate seal.
•
Correct centring of the suction plate on the load centre of gravity.
•
Check the cleanliness of the paper and cloth filters. If they become dirty and/or wet, the lifting capacity
will be reduced.
•
Rough handling during operation.
•
This unit is designed for one person to set paving stones and slabs.
52600018 6 / 17 GB